Kiln Support
  
Paragon HomeKiln ProductsWhere To Buy KilnsKiln SupportAbout ParagonKiln Resellers and Dealers
Search Menu

Kiln Pointers

A Simple Heating Element Repair

Ordinarily the only way to repair a burned-out element is to replace it. The exception: When an element burns out at the connector, you may be able to install a new connector and salvage the element.

Elements rarely burn out at the connector. This type of failure is due to a loose connection, which builds up enough heat in the connector to break the element wire. This is why it is important to securely tighten element connectors when replacing an element.

The following instructions are for Paragon kilns, which use barrel connectors. If your kiln uses a different type of connector, the basic principle still applies.

You have a burned-out element. To replace the element or connector, disconnect the kiln and remove the switch box (control panel) from the kiln. You will see two element connectors for each element in your kiln.

If the element has burned at the connector, you will usually see a bare, twisted section of element with a missing connector. This is because the element connector falls off the broken element end.

Does the burned element end have enough length so that you can install another element connector? (With Paragon’s barrel connector, you will need about 1/2” of element length to install another connector.) If not, gently pull the element end with needle-nose pliers. There is sometimes play in the element. If so, you will feel the play as you pull the element end toward you.

If you have 1/2” of exposed length at the element end, you can install a new element connector and salvage the element. Please do not remove the porcelain insulator located under the element. (Not all kilns have porcelain insulators, by the way.) Removing the insulator will give you extra element length, but the insulator is there to prevent the element from shorting out against the kiln case.

Check the element lead wire for heat damage by bending the wire. If the insulation is brittle, replace the wire.

Wishing you a great summer,

Arnold Howard Paragon Industries, L.P. - Better Designed Kilns 2011 South Town East Blvd. Mesquite, TX 75149-1122 Voice: 972-288-7557 & 800-876-4328 / Fax: 972-222-0646 arnoldhoward@att.net / www.paragonweb.com



Paragon Kilns on FacebookParagon Kilns on Twitter Paragon Kilns on YouTube Paragon RSS Feed

Kilns Sold

Get The Adobe Reader

Home

  • Home
  • Privacy Statement
  • Legal Notice
  • Paragon's Green Statement
  • Where To Buy Kilns
  • Resellers
  • About Us
  • Contact Paragon
  • News & Events
  • Support

  • Kiln Technicians
  • Kiln Support
  • Products

  • Bead Kiln
  • Glass Blower's Crucible Furnace
  • Ceramic Kilns
  • China Painting Kilns
  • Enameling Kilns
  • Industrial Furnaces
  • Glass Kilns
  • Lamp Working Kilns
  • Pottery/Ceramic and Glass
  • Pottery Kilns
  • Silver Clay Kilns
  • Wax Burnout Furnaces
  • Heat Treating Furnaces
  • Knife Making Furnaces
  • Custom Furnaces
  • Discontinued Models
  • “Custom and standard Kilns and Industrial Furnaces for ceramics, pottery, heat treating, enameling,
    dentistry, laboratory, and glass fusing.
    Better Designed Kilns from Paragon Industries!"